Microsoft Computer Hardware System Board Manuale Utente Scaricare il pdf (Pagina 14)

Hardware Installation

2.3 DIP Switch Settings for Processors

(For Factory Use Only)

You cannot overclock an Intel Celeron

PPGA processor because

its frequency ratio has been fixed by the manufacturer. Therefore

SW1 on the system board is used for factory testing only. The table

on the next page, which shows the supported processors and their

corresponding DIP switch settings, are for reference.

In the example above:

Switch 1: Off

Switch 2: On

Switch 3: Off

Switch 4: On

1. Pull the tabs which are at the ends of the socket to the side.

2. Position the DIMM above the socket with the notches in the

module aligned with the keys on the socket.

3. Seat the module vertically into the socket. Make sure it is

completely seated. The tabs will hold the DIMM in place.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Nessun commento

Microsoft Computer Hardware System Board Manuale Utente Pagina 14